|VSP-2 Dual Mic Preamp 1976|
The VSP-2 is VERTIGO SOUNDs 3rd BIG IMPACT DESIGN and is setting a new benchmark in microphone amplification.
The heart of this unit is Vertigo Sound 100% discrete Twin Op Amp circuit called the OPA (operational amplifier) 1976.
These "in house" engineered & built discrete amplifier stage is combined with Jensens world famous JT-16 Mic transformers and provide a smooth warm and defined sound from the lowest bass to the very top end of the sonic spectrum.The JT-16 transformer can handle very high input levels and provides a very linear phase behaviour because of low capacitance problems due to it`s low ratio of 1:2. Further the low ratio of the transformer forces the discrete OP Amp to provide most of the amplification in the VSP-2. This " full throttle","pedal to the floor" circuitry enables a unique, rich, full and characterful sound.
|Controls and Features of the VSP-2|
Fine Gain control:
Signal & Clip LED:
Note: The maximum output of the VSP-2 is +24dbU, the red clipping led indicates the maximum capable input level of most common converters and analog gear.
Please use the Pad for the gain Settings 12dB-18db-24dB and 30dB only!!! The Pad does not effect the sound of your signal but settings like 54dB with Pad engaged e.G. will worsen your signal to noise ratio.
|• Dual Mono Mic pre with 1,5K input impedance
• Jensen Balanced In. That 1646 Balanced Out
• Dynamic Range: 116 db @ 36dB Gain
• Frequency response: 10 Hz … 35 kHz (+– 1db) @ 36dB Gain
• Max. Output Level: + 24 dBu / 600 Ohm balanced floating
• Noise: -81dBu (20 Hz – 22 kHz – unweighted, RMS) @ 36 db Gain